SWG meaning in Measurement Unit ?

British Standard Wire Gauge (often abbreviated to Standard Wire Gauge or SWG) is a unit for denoting wire size given by BS 3737:1964 (now withdrawn). It is also known as the Imperial Wire Gauge or British Standard Gauge. Use of SWG sizes has fallen greatly in popularity, but they are still used as a measure of thickness in guitar strings and some electrical wire. Cross sectional area in square millimetres is now the more usual size measurement for wires used in electrical installation cables. The current British Standard for metallic materials such as wire and sheet is BS 6722:1986, which is a solely metric standard.

SWG was fixed by Order of Council August 23, 1883. It was constructed by improving the Birmingham Wire Gauge. It was made a legal standard on March 1, 1884 by the British Board of Trade. SWG is not to be confused with American Wire Gauge, which has a similar but not interchangeable numbering scheme.

A table of the gauge numbers and wire diameters is shown below. The basis of the system is the thou (or mil in US English), or 0.001 in. Sizes are specified as wire diameters, stated in thou and tenths of a thou (mils and tenths). The wire diameter diminishes with increasing size number. No. 7/0, the largest size, is 0.50 in. (500 thou or 12.7 mm) dia., No. 1 is 0.30 in. (300 thou), and the smallest, No. 50, is 0.001 in. (1 thou or about 25 µm).

The system as a whole approximates a (constant-ratio) exponential curve. The weight per unit length diminishes by an average of approximately 20% at each step. Because the weight per unit length is related to the cross sectional area, and therefore to the square of the diameter, the diameter diminishes by approximately 10.6%:

But the system is piecewise linear, only approximating the exponential curve loosely. Thus it runs in constant steps of 0.4 thou (0.4 mil) through the range No. 49 - No. 39 and 0.8 thou (0.8 mil) through No. 39 - No. 30.