Duct friction chart is prepared on​

The equal FRICTION method of sizing DUCTS is recommended because it does not require a great deal of experience in the selection of proper velocities in the various sections of the duct system. It is necessary to select the main duct velocity consistent with good practice from a standpoint of noise for a particular BUILDING or application. In this duct-sizing method, the duct design is based primarily on a consistent pressure loss for each foot of duct.Proportioning for equal friction is more advantageous than reducing the velocity in a haphazard manner because the friction calculation is greatly simplified. In calculating the friction, it is necessary to know only the length of the longest run, the number and size of elbows, and the diameter and velocity of the largest duct. The friction loss is exactly the same as though the entire amount of AIR were carried the whole distance through the largest duct.The air velocities listed in Table 7-5 have been FOUND to accomplish satisfactory results in engineering practice. Where quiet operation is essential, the blower or fan should be selected on the basis of a low outlet velocity. This will also result in lower operating costs.